Laser cutting

Laser Cutter Head Diagram What is it laser cutting? Laser cutting is a fairly new technology that allows metals and some non metallic materials to be cut with extreme precision if required. The laser beam is typically 0.2 mm in diameter with a power of 1-2 kW . Types of laser cutting Depending on the application of the laser cutter a selection of different gases are used in conjunction with the cutting. For general boring, cutting and engraving then Co2 is typically used. If high powered laser pulses are used then neodymium (Nd) gas is required, this set up is mainly associated with boring. For a constant high powered beam neodymium yttrium-aluminium-garnet (Nd-YAG) is used. Gaseous laser cutting uses an electrical current pumped through the gas which gives the laser its cutting properties, however this has recently been revised and RF energy is now preferred as this method does not require the use of electrodes like the DC current does. These electrodes were susceptible to erosion What can it do? Laser cutting can cut through a wide range of different materials, these can range from acrylic, wood, paper and foam core to high carbon and stainless steels, Laser cutting is not best suited to metals such as aluminium and copper alloys as they have good heat conductive and light reflective properties, these materials require the use of a more powerful laser. Laser cutters are generally best suited to thin materials of <12mm. Advantages Contamination of materials while laser cutting is reduced as there is no real physical contact between metal and cutter. Great accuracy as laser can be focused into very small points, and there is also no wear in a laser while it is cutting as there is with more conventional methods, such as milling. There is also a reduced chance of warping the material when laser cutting as the laser only generates a small area of heat. No mechanical force is applied therefore no physical damage can occur. Disadvantages Laser cutting has high energy consumption, and can draw a lot of power to perform its cutting. Although it uses a large amount of power it goes some way to making up for this cost with its fast and precise cutting speed. The cost and setup of a laser cutter can also be expensive when compared to other methods. Work hardening along the edges of cuts can mean harder work if any further machining is required.

K@run@